Descargar Imprimir esta página

Coelbo T-KIT SWITCHMATIC 2 Manual De Instrucciones página 11

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

WARNINGS AND ALARMS
DESCRIP-
COD.
TION
O
DRY-RUN-
NING
A01
(Only for
T-Kit Swit-
chmatic 2)
( ( O ) )
DRY-RUN-
NING (BY
A11
O
MINIMUM
PRESSURE)
O
OVERLOAD
A02
(Sólo SW2)
( ( O ) )
FAST
CYCLING
A04
(((O)))
(Hamme-
ring)
SYSTEM REACTION
When is detected a dry-
run operation the pump is
automatically stopped. By
mean of ENTER the normal
operation can be manually
restored.
After the activation of the
dry-running alarm if the
Automatic system reset
(ART) is enabled, a first
attempt at 5 minutes and
then an attempt every
30 minutes for 24 hours
is performed in order to
restore the normal opera-
tion. This alarm can also
be reset manually with the
ENTER push-button. If the
alarm persists after 24 h
we find a definitive alarm.
Is displayed during normal
operation if the pressure
is below the minimum
pressure (Px.x) - previously
set - during a period (txx) -
also previously set - in the
ADVANCED MENU.
If at any time the pressu-
re exceeds the minimum
pressure, the operation is
restored automatically and
the alarm is cleared.
Normal operation can also
be restored manually by
pressing ENTER.
Overcurrent alarm is acti-
vated when the nominal
pump current is exceeded.
4 automatic reset attempts
prior to the final alarm are
performed.
During the attempts dis-
play will show current.
Normal operation can also
be restored manually by
pressing ENTER.
This alarm can be unabled
or activated in the BASIC
MENU. The alarm is acti-
vated when 3 consecutive
cycles occur in a range
lower than the set time
(between cycles).
If it has been activated rc1,
this alarm does not stop
the normal operation but
are added 5 seconds to
the start delay in order to
protect the electric pump.
If it has been activated rc2,
the pump is stopped.
To RESET the normal ope-
ration press ENTER.
DAMAGED
PRESSURE
A05
O
TRANSMIT-
TER
EC STAMENT OF COMPLIANCE
COELBO CONTROL SYSTEM, S.L.
States, on our own responsibility, that all materials here with
related comply with the following European Directives:
- 2014/35/EU.
- 2014/30/EU.
- 2014/65/EU.
Name: - T-Kit Switchmatic 1
- T-Kit Switchmatic 2
Standards : EN 60730-1:2000+A12:2003+A13:2004+A1:2004
+A14:2005+
A15:2007+A16:2007+A2:2008 / EN 60730-2-6:2008
UNE-EN 60730-1:2003+A12:2004+A13:2005+A1:2005
+A14:2007+ CORRIG:2007+A15:2008+A16:2008+A2:2009 /
UNE-EN 60730-2-6:2009
EN: 61000-6-1:2007+A1:2012/EN: 61000-6-3:2007+A1:2012
F. Roldán Cazorla
Director Técnico
04/05/2016
COELBO CONTROL SYSTEM, S.L.
Ctr de Rubí, 288 - P.I. Can Guitard
08228 Terrassa - BARCELONA (SPAIN)
11
CONTACT WITH YOUR
SUPPLIER.

Publicidad

loading

Este manual también es adecuado para:

T-kit switchmatic 1