Publicidad
Step 8
å
Fasten the LEFT FRAME (R) to the LEFT END (C).
Tighten four 1/2" HEX HEAD SCREWS (16) using
the L-WRENCH (5).
å
Fasten the RIGHT FRAME (S) to the RIGHT END (D).
Tighten four 1/2" HEX HEAD SCREWS (16) using
the L-WRENCH (5).
å
NOTE: You should start each SCREW a few turns
before completely tightening any of them.
å
Peel the PADS from the PAD CARD (8) and apply
them to the bottom of the FRAMES (R and S).
1/2" HEX HEAD SCREW
(8 used in this step)
430075
C
R
16
5
www.sauder.com/service
Side Step: Make
nachos. (Optional, but
recommended.)
16
S
D
8
Page 13
Publicidad
