Publicidad
Step 15
å
Before fastening the DOOR to your unit, be sure the
mounting screw is against the stops as shown in the
right diagram. If it isn't, loosen the adjusting screw and
mounting screw to slide it against the stops. Then tighten
the mounting screw.
å
Fasten the DOORS (P and Q) to the ENDS (C and D) as
shown in the lower diagram. Use sixteen SILVER 1/2"
FLAT HEAD SCREWS (19). You should start each screw a
few turns before completely tightening any of them.
å
Fasten a PULL (6) to each DOOR (P and Q). Use four 1/2"
PAN HEAD SCREWS (17).
å
See the next step for DOOR adjustments.
C
1/2" PAN HEAD SCREW
(4 used for the PULLS)
Page 20
P
17
www.sauder.com/service
Stop
Mounting
screw
Adjusting
screw
D
6
17
Hinge
19
SILVER 1/2" FLAT HEAD SCREW
(16 used for the HINGES)
17
Q
430075
Publicidad
