Publicidad
Step 4
å
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (1) to the ENDS (C and D). Use six BLACK 1/2" FLAT HEAD SCREWS (18).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the ENDS. Turn a SCREW
into these holes.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
2
Push the black lever and pull the SLIDE from the RAIL.
Open end
430075
BLACK 1/2" FLAT HEAD SCREW
(6 used in this step)
1
C
www.sauder.com/service
1
Use these holes.
18
D
7
1
Open end
Page 9
Publicidad
