Angelo Po 0S0GRE Manual De Uso página 29

SAFETY
► Source of hazard: Appliance mechanics
Hazard
Risk of crushing parts
of the body in case of
tip-over or fall of the
appliance
HAZARDS AND SAFETY PROVISIONS DURING ASSEMBLY
When assembling the appliance, watch out for the following hazards and provide for the
countermeasures indicated below:
► Source of hazard: Handling of heavy loads
Hazard
Risk of injury due to
body overload
3378610_ut_GB
Where or in which situations
does the hazard occur?
• When the appliance moves • Use a suitable lifting
Where or in which situations
does the hazard occur?
• When the appliance moves • Use a suitable lifting de-
Countermeasures
device
• Pay attention to the
centre of gravity
• Avoid collisions
Countermeasures
vice to place the appliance
on the work bench, on the
base
• Adjust the position only if
a suitable number of peo-
ple is available, otherwise
observe the limit values for
lifting and transport
• Comply with the applica-
ble laws on accident pre-
vention for the installation
place
• Wear personal protective
equipment
ENGLISH
Safety
device
None
Safety
device
None
5