Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING YOUR UNIT
Adjust the temperature
Start-up for a test:
To use as a freezer, you may set the temperature control dial at the "4" (max) position by turning
the knob clockwise from the starting or "1" (min) position. After 24 hours, adjust the control to the
setting that best suits your needs.
When open the door can feel some cold air come out after being electrified for around 30 minutes,
it indicates that the refrigeration system operates normally;
It's normal that the both sides of the freezer are warm when it is in operation.
NOTE:
"4" (max):
"2 and 3" (normal):
"1" (min):
Cut off the power when no using for long time.
If the unit is unplugged, power cut, or turned off; you must wait for 3 to 5 minutes before restarting
the unit. If you attempt to restart before this time delay, the unit will not start.
When storing the food, clean-wrapped it or store in a container with a lid, this prevents smell and
keep dry.
There should be proper space between food, do not put into too much food.
For saving electricity, do not open the door frequently.
DEFROSTING YOUR UNIT
When? For the most efficient operation and minimum energy consumption, defrost the unit
compartment when the frost on the evaporator wall is excessive or ¼ of 2,5 cm thick.
How? To start defrosting, unplug the unit, remove the food and shelf. After the frost or ice has
melted, discard the melted water and dry up the interior of unit. Then the unit can be restarted by
turning its thermostat to the desired setting.
Means strong cooling
Means normal cooling
Means weak cooling
37
Publicidad
