Selco Genesis 2700 PMC Instrucciones De Uso página 50

4.4 RC 190 remote control
1
Allows continuous adjustment of the wire feed speed.
Allows the regulation of the welding current.
Allows the thickness of the part being welded to be set.
Allows the setting of the system via the regulation of the
part being welded.
2
Allows the regulation of the arc voltage.
Allows regulation of the arc length during welding.
Manual MIG/MAG
High voltage = long arc
Low voltage = short arc
Minimum 5V, Maximum 55.5V
Synergic MIG/MAG
Minimum -5.0, Maximum +5.0, Default syn
Operation of the remote control is activated when it is con-
nected to the connector on the Selco power sources. This con-
nection can be made also with the system switched on.
4.5 RC 200 remote control
The RC 200 is a remote control unit designed to manage the
display and the adjustment of all available parameters of the
power source to which it is connected.
4.6 MIG/MAG series torches
1 Torch button
"Consult the instruction manual".
50
4.7 U/D MIG/MAG series torches
The U/D series torches are digital MIG/MAG torches allowing
the main welding parameters to be controlled:
- welding current
- program recall
(Consult the "Set up" section).
"Consult the instruction manual".
4.8 DIGIMIG - MIG/MAG series torches
The MB501D PLUS series torches are digital MIG/MAG torches
allowing the main welding parameters to be controlled:
- welding current (Synergic MIG/MAG process)
- arc length (Synergic MIG/MAG process)
- wire speed (Manual MIG/MAG process)
- welding voltage (Manual MIG/MAG process)
- program recall
and the real values to be displayed for:
- welding current
- welding voltage
4.9 Push-Pull series torches
1 Torch button
"Consult the instruction manual".