Publicidad
Idiomas disponibles
Idiomas disponibles
1. Remove the grass catcher.
2. Remove the battery and safety key.
3. Pull through the handle holes to fold away the handles.
4. Lock the handles into position.
5. Stand the machine on end and make sure that the brackets
touch the floor.
12
TROUBLESHOOTING
Problem
Possible cause
The handle is not
The bolts are not
in position.
engaged correctly.
The machine does
The battery ca-
not start.
pacity is low.
The start handle is
defective.
The battery key is
not put in.
The machine cuts
The lawn is rough. Examine the mow-
grass unevenly.
The blade height is
not set correctly.
The machine does
Wet grass clip-
not mulch correct-
pings attach to the
ly.
deck.
The mulch plug is
missing.
The machine is
The grass is too
hard to push.
tall, or the blade
height is too low.
The grass catcher
and the blade
drags in thick
grass.
English
Problem
There is a high vi-
bration in the ma-
chine.
Solution
Adjust the height
of the handle and
make sure that the
bolts and nuts are
aligned correctly.
Charge the battery
pack.
The machine stops
Replace the start
during mowing.
handle.
Put in the battery
key.
ing area.
Move the wheels
to a higher posi-
tion.
Wait until the
grass dries before
* If you cannot find the solution to these problems, go to the
mowing.
service center.
Install the mulch
13
plug.
Increase the blade
Voltage
height.
No load speed
Deck size
Empty the grass
clippings from the
Height adjustments
grass catcher.
Functions
Weight (without battery
pack)
Battery model
Charger model
13
Possible cause
The blade is un-
balanced and
worn.
The motor shaft is
bent.
The blade height is
too low.
The battery pack is
out of power.
The grass clip-
pings attach to the
deck or the blade.
Operation temper-
ature of the ma-
chine is too high.
TECHNICAL DATA
24V/48 V
2850/3250 RPM
21"
1 3/8 - 4" (3.5- 10.2 cm)
3-in-1 Mulch & Rear Bag &
Side Discharge
57 lbs (26 kg)
48B25A and other BAM ser-
ies
48DPC4A and other CAM
series
EN
Solution
Replace the blade.
1. Stop the mo-
tor.
2. Remove the
safety key and
battery pack.
3. Disconnect the
power source.
4. Inspect for
damage.
5. Repair the ma-
chine before
you start it
again.
Increase the blade
height.
Charge the battery
pack.
Remove the bat-
tery pack and
check the deck.
Cool the machine.
Publicidad
