Husqvarna TS 138 Manual De Usuario página 34

Problem
The battery does not charge.
The engine operates when the oper-
ator gets up from the seat when the
cutting deck is engaged.
The blades cannot rotate.
Damaged grass discharge.
34
Cause
The main fuse is damaged.
The battery is damaged.
The charging cable is disconnected.
The connection at the cable connec-
tors on the battery terminals is bad.
The operator presence control (OPC)
does not operate correctly.
There is blockage in the clutch mech-
anism.
The drive belt for the cutting deck is
worn or damaged.
An idler pulley is frozen.
A blade mandrel is frozen.
The engine speed is too slow.
The product is operated at too high
forward or rearward speed.
The grass is wet.
The cutting deck is deck not parallel.
The tire pressure is incorrect.
The blades are worn, damaged or
loose.
Buildup of grass or dirt below the cut-
ting deck.
The drive belt for the cutting deck is
worn or damaged.
The blades are incorrectly installed.
Incorrect blades are used.
Clogged air holes of the cutting deck
from buildup of grass, dirt around
mandrels.
Action
Replace the main fuse.
Replace the battery.
Connect the charging cable.
Do a check of the battery connec-
tions.
Do a check of the wires, switches
and connections. If not corrected,
speak to an approved service agent.
Do not use a product with an oper-
ator presence control that does not
operate correctly.
Remove the blockage.
Replace the drive belt for the cutting
deck.
Replace the idler pulley.
Replace the blade mandrel.
Put the throttle control in the fast po-
sition.
Use slower speed.
Let the grass become dry before you
cut it.
Adjust the parallelism of the cutting
To adjust the parallel-
deck. Refer to
ism of the cutting deck on page 26 .
Do a check of the tire pressure. Ad-
just the tire pressure if it is necessa-
ry.
Replace blades or tighten bolts on
the blades.
Clean the cutting deck.
Replace the drive belt for the cutting
deck.
Install the blades with the sharp edge
down.
Replace the blades with the correct
blades in the parts manual.
Clean around mandrels to open air
holes.
1701 - 009 - 14.07.2023