Parkside PDSA 20-Li B2 Manual De Instrucciones página 36

GB MT
The­device­can­now­be­carried­over­the­
shoulder­with­the­carrying­strap­(9)­in­ad-
dition to the handle (12).
Filling tank
­ The­tank­can­be­filled­with­water­
or­water-soluble­plant­protection­
agents.
Please take notice of the safety in-
formation­and­instructions­provided­
by­the­manufacturer­of­the­plant­
protection­agent.­Wear­the­perso-
nal­protective­equipment­recommen-
ded by the manufacturer.
Caution! Take precautions against
contact with and/or inhalation of
hazardous substances. Wear suitable
personal protective equipment according to
the instructions of the manufacturer of the
plant protection product!
Caution!
Do­not­fill­with­acidic,­corrosive­or­
flammable­liquids.­
Caution! Do­not­fill­with­impregna-
ting­agents­or­disinfectants,­varni-
shes, glazes, greases, mineral oils
or­synthetically­produced­oils.
The­container­(10)­can­be­filled­with­a­
maximum of 5 litres of liquid.
1.­­ Place­the­pressure­sprayer­on­a­level­
surface.
2­ Turn­the­screw­cap­(11)­anticlockwise.­­
36
Pour in the liquid. Pay attention to the
scale (16) on the container (10) so
as­not­to­exceed­the­maximum­filling­
quantity.
3.­ After­filling,­screw­the­screw­cap­(11)­
clockwise with both hands.
4.­ Make­sure­that­the­screw­cap­fits­tightly.
Mix only as much liquid as
you­need­for­the­application.
Charging­the­battery
If warm, allow the battery to cool
before charging.
The­battery­indicator­on­the­device­dis-
plays­the­battery­(21)­charge­level.
1.­ If­necessary,­remove­the­batter­(21)­
from­the­device.
2. Slide the battery (21) into the charging
slot of the charger.
3. Plug the charger into an outlet.
4.­ Once­charging­is­complete,­disconnect­
the­charger­from­the­mains­supply.
5.­ Remove­the­battery­(21)­from­the­charger.
Operation
Caution! Take precautions against
contact with and/or inhalation of
hazardous substances. Wear suitable
personal protective equipment according to
the instructions of the manufacturer of the
plant protection product!
Check the device for obvious de-
fects, e.g. cracks, before each use.
Also check the proper functioning of
the nozzle.