Parkside PDSA 20-Li B2 Manual De Instrucciones página 37

Removing/inserting­the­
battery
The­device­can­be­operated­either­with­
X 20 V TEAM­or­X 12 V TEAM­batteries.
1.­Fold­up­the­battery­cover­(15).
2. There are 2 different battery
compartments.­­
The­upper­battery­compartment­(
intended­for­use­with­the­12­V­battery.­­
The­lower­battery­compartment­(
intended­for­the­20­V­battery.
3. Push the desired battery (21) fully into
the­corresponding­compartment.­You­will­
hear­it­click­into­place.
4.­To­remove­the­battery­(21)­from­the­
device,­press­the­release­buttons­(20)­on­
the­battery­and­pull­the­battery­out.
Charge­level­indicator
To check the charge of the battery during
operation,­press­the­charge­control­button­
(27).
The­LEDs­above­it­now­show­the­current­
charging­status:
Green-yellow-Red­-­battery­charged
yellow-Red­-­battery­only­partially­charged
Red­-­battery­is­flat­-­please­charge­the­
battery
Switching on/off
Make­sure­that­the­battery­has­been­put­in­
correctly.
1. To switch on,­move­the­on/off­switch­
(17)­to­position­"I".
2. To switch off,­move­the­on/off­switch­
(17)­to­position­"O".
Adjusting the nozzle
The­spray­nozzle­(8)­is­infinitely­adjustable­
from­spray­mist­to­jet.
25) is
•­ Turning­to­the­left­from­the­user's­view-
26) is
point­=­spray­mist
•­ Turning­to­the­right­makes­the­beam­
selectively­more­intense.­
Attention: you can also unscrew
the­spray­nozzle­(8)­if­you­turn­it­
too far to the right
Spraying
Note that recoil forces may occur
when pressing the trigger lever (2)
on the pistol grip (1). Always keep
a good hold on the pistol grip.
Always­spray­directly­and­solely­onto­the­
plants­or­objects­to­be­sprayed.­
To­avoid­damage­to­the­environment,­the­
operator­or­bystanders,­select­an­appropri-
ate nozzle setting.
Located on the trigger gun (1) is a
small­lever­which­blocks­the­trigger­
lever­(2)­against­unintentional­pressing.­To­
spray,­you­need­to­fold­the­small­lever­into­
the­trigger­lever­(2).
GB MT
37