Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
PROBLEM
Machine is not running and Coffee Button light continuously
displays 2 blinks Red and 1 pause.
Leakage or unusual coffee flow.
Machine enters standby.
Coffee grounds in the cup.
Coffee light on, but no light on milk side.
Descale alert LED is blinking.
Descale alert LED is on and Steam does not work.
Milk steam cycle does not start.
POSSIBLE CAUSES
During regular Coffee/Espresso preparation:
•
1) Unlock the handle and open the machine head
to check that a fresh undamaged capsule is inserted
in the correct position.
2) Check that the handle is in the "locked" position.
3) Check that the water tank is full.
During Descaling, Emptying and Cleaning:
•
1) Check that capsule is ejected.
2) Check that the handle is in the "locked" position.
During Programming Volume:
•
1) Check and insert a capsule.
2) Please refer to the corresponding chapter.
Check that the water tank is correctly positioned.
•
To save energy the machine will turn off after
•
2 minutes of non-use.
Perform the cleaning procedure twice.
•
Machine communication error
•
Machine requires descaling in order to achieve
•
optimal performance.
Check that the water tank is correctly positioned.
•
Check steam tip for any blockages and ensure wand is lowered
•
into the correct position
Check if a coffee brew is in progress as steam can only start
•
after the coffee is finished.
Check if the descale alert is showing and then requires
•
a descale.
Check if the "clean" led is indicating that the steam wand
•
requires a clean.
25
EASY SOLUTION
If problem persists:
•
1. Unlock the handle and open machine head.
2. Replace capsule (if needed).
3. Disconnect power cord from the outlet and plug the machine
back into outlet after 10 seconds.
4. Close the head and press the button to turn "on" and press
again to start brewing. If problem persists, call Nespresso.
See Energy Saving Concept Section.
•
See Cleaning the coffee system section.
•
Unplug the machine, wait 10 seconds, plug in the machine,
•
wait 10 seconds, press steam button.
Descale the machine.
•
Fill water tank.
•
Complete a steam wand cleaning cycle.
•
Complete a descale cycle.
•
EN
Publicidad
