Parkside PHSL 900 B4 Traduccion Del Manual De Instrucciones Originale página 11

NOTE
► Notes on the working position (see fold-out
page).
► Notes on the control elements (see fold-out
page).
► Notes on exchange and repair (see section
Maintenance and cleaning/service).
► Explanation of all graphical symbols used on
the hedge trimmer and technical data can be
found in these instructions.
► The features of the hedge trimmer can be
found in the technical data.
► Blocked tool: remove the jammed material
from the cutter bar e.
CAUTION!
► In the event of imminent danger or an emer-
gency switch off the motor immediately and
unplug the appliance.
Supplementary safety instructions
for hedge trimmers
Preparation
a) THIS HEDGE TRIMMER CAN CAUSE SERIOUS
INJURIES! Read the instructions on correct
handling, preparation, maintenance, starting
and stopping the hedge trimmer very carefully.
Familiarise yourself with all control elements
and the proper use of the hedge trimmer.
b) Children must never use the hedge trimmer.
c) Beware of overhead power lines.
d) Do not use the hedge trimmer while other
people, especially children, are in the vicinity.
e) Wear suitable clothing! Do not wear loose
clothing or jewellery that could get caught
in moving parts. We recommend wearing
heavy-duty gloves, non-slip footwear and
goggles.
f) If the cutting unit comes into contact with a
foreign object, the operating noise increases or
the hedge trimmer starts to vibrate abnormally,
stop the motor and allow the hedge trimmer
to come to a standstill.
Take the following measures:
PHSL 900 B4
– check for damage;
– check for loose parts and secure all the
loose parts;
– replace damaged parts with equivalent
parts or have them repaired.
g) Wear hearing protection!
h) Wear safety goggles!
i) To stop the hedge trimmer in an emergency,
pull the mains plug from the mains socket.
Operation
a) Remove the plug from the wall socket before:
– cleaning or removing blockage;
– inspection, maintenance or work on the
hedge trimmer;
– setting the working position of the cutting
unit;
– if the hedge trimmer is left unattended.
b) Always make sure that the hedge trimmer is
in the proper working position and the tool
head is properly engaged before the engine
is started.
c) While operating the hedge trimmer, always
ensure that you have firm footing, especially
when using steps or a ladder.
d) Do not use the hedge trimmer if it has a
defective or badly worn cutting unit.
e) Ensure that all supplied handles and safety
guards are mounted when operating the hedge
trimmer. Never attempt to operate an incom-
pletely assembled hedge trimmer or a hedge
trimmer with non-approved modifications.
f) Hold the hedge trimmer firmly with both hands
on the designated handles.
g) Always familiarise yourself with your surround-
ings and be aware of potential dangers that
you may not be able to hear because of the
noise of the hedge trimmer.
GB │ IE │ 7 ■