Publicidad
Idiomas disponibles
Idiomas disponibles
U
I
S
1.3
Description
X-ONE is the new solution by EMMETI, a significant step
towards reducing the aesthetic impact of air conditioners.
Being only 16 centimetres deep, X-ONE is the thinnest
and less bulky in its category, therefore both the internal
and external aesthetic impact is kept to a minimum.
Optimised Capacities
The conditioning capacities of X-ONE have been optimised
so as to obtain the right temperature for the best level of
comfort and, therefore, less consumption and less noise.
Thanks to the careful choice of sound insulation materials,
the noise is similar to that of a standard wall split unit and
consumption is drastically contained thanks to the new
direct current fan.
162 millimetre holes
An important choice not only design-wise, but also because
of a considerable installation advantage: it is easier to find
drilling tools as there's no need for professional ones, with
lower aesthetic impact.
1.4
Receipt and unpacking
The packing is made of suitable material and carried out
by expert personnel. All units are checked and tested and
are delivered complete and in perfect conditions, however
please perform the following instructions to check the
quality of shipping services:
-
upon receipt, check if the box is damaged. If that is
the case, accept the goods with reservations and
keep photographic evidence of any damage found
-
unpack and check the contents against the packing
list
-
check that none of the parts have been damaged
during shipment.
1.5
Storage
Store the box in a closed environment protected from
atmospheric agents and isolate it from the floor using
planks or pallets.
1.6
Handling
The unit is packed singularly in a cardboard box. Boxes
can either be carried singularly by hand by two operators
or loaded on a cart, for a maximum of three units.
Handling must be performed by qualified personnel,
with specific tools and with equipment suitable for the
weight of the appliance.
The appliance is unbalanced on the right (compressor
side)
Easy to install
X-ONE can be installed on any perimeter wall either low or
high. Everything needed for installation (template, support
bracket, hole pipes and external grids), excluding the drill,
is included in the box.
Folding external grids
X-ONE is equipped with folding grids activated by inlet
and outlet air. They open when the unit is working and
close when it's turned off. Better indoor comfort, less
dust, noise and pollution, less maintenance and even less
outdoor visibility.
Remote control and touch-screen display
In addition to the remote control, the touch-screen
display on the unit enables the setting of any function.
There's even a "lock" mode to avoid any improper use.
It is possible to deactivate the "heating" mode by simply
touching the screen. The unit then works in "cool only"
mode, without the need to use the condensation drain
pipe. The orientation of the air flaps can also be adjusted
by simply pressing one key.
Keep the packing at least for the whole length of
warranty should you need to ship the appliance to
the service centre for repair. Dispose of the packing
materials in compliance with current regulations on
waste disposal.
Do not turn upside down.
During transportation, the appliance must be kept in
vertical position.
GENERAL
EN
31
Publicidad
