Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
Key/Display
46
Operation
Switching the appliance on and off
It is possible to switch the appliance on or off (stand-by) by pressing the specific button. The control system of the
appliance is equipped with a memory, so settings won't be lost if the appliance is switched off or in the event of low
voltage. The button must be used to activate or deactivate the appliance for short periods of time.
In case of long periods of inactivity, the appliance must be deactivated disconnecting either the main switch or the
plug from the socket.
Well-being button (economic automatic mode)
By choosing this mode on the appliance, it is set so as to obtain the best level of comfort in the room. The conditioner
selects the mode automatically (cooling or heating) according to the temperature set and ventilation speed according
to the temperature of the room.
Cooling only mode
•
In this mode, the appliance dehumidifies and cools the room.
•
It is possible to set the desired temperature between 16 and 31°C and, if such temperature is lower than the room
temperature, the compressor starts up after three minutes (maximum) and the appliance starts dispensing cool
air, maintaining ventilation active even if the setpoint has been reached.
Dehumidification only mode
In this mode, the appliance dehumidifies the room. Selecting this mode is useful during mid-seasons, that is to say
during those days (e.g. rainy ones) when the temperature is rather pleasant, but excess humidity causes discomfort.
This mode ignores both room temperature and ventilation speed settings. The latter is always set to a minimum. It is
normal for the appliance to work intermittently.
Ventilation only mode
By selecting this mode, the compressor is not activated and the appliance does not intervene on room temperature or
humidity. IT is possible to choose the fan speed.
Heating only mode
•
In this mode, the appliance heats the room.
Set on heating only mode, the appliance defrosts the evaporative battery periodically if necessary. During this
phase, the conditioner does not dispense warm air, even if its internal organs are on except for air ventilation.
•
It is possible to set the desired temperature between 16 and 31°C and, if such temperature is higher than the
room temperature, the compressor starts up after three minutes (maximum) and the appliance starts dispensing
warm air.
Nocturnal well-being button
While the appliance is on in the selected cooling or heating mode, it is possible to choose different functions by
pressing the button in order to maximise noise reduction, energy saving and nocturnal well-being regulation.
In this mode, ventilation is set on minimum speed.
This mode should be activated right before going to sleep.
•
In cooling mode, the set temperature is risen by 1°C after one hour and by another degree after two. After the
second hour, the temperature is no longer changed and, after six hours, the appliance is put in stand-by.
•
In heating mode, the set temperature is lowered by 1°C after one hour and by another degree after two. After the
second hour, the temperature is no longer changed and, after six hours, the appliance is put in stand-by.
This function is not available for dehumidification only, ventilation only and economic automatic modes and can be
excluded any time (ideally once awake) by pressing the button again.
If the Timer has also been set, the appliance will turn off at the set time.
Control of air flow direction
By pressing the specific button, it is possible to select the continuous oscillation of the mobile air outlet flap - in such
case, the symbol on the display is lit - or to block it in any position.
IMPORTANT: The mobile flap must never be moved manually.
U
I
S
Publicidad
