Publicidad
Idiomas disponibles
Idiomas disponibles
U
I
S
2.7
High/low installation configuration
The unit can be installed either in the lower part (near the
floor) or in the upper part (near the ceiling) of the wall. In
order to optimise air distribution and comfort, the direction
of the air flow can be modified by adjusting the position of
the air flap.
The appliance is supplied ready to be installed in the lower
part of the wall, so air is dispensed upwards. The same
configuration can also be used in the upper part of the wall
Adjust the air outlet flap configuration from the lower wall position to the upper wall position.
-
Open the air outlet flap gently
-
Remove the flap opening block insert located internally
on the right of the air outlet mouth and place it in the
lower hole.
A
B
After adjusting the air outlet flap position, it is necessary to
set up the electronic control of the appliance:
-
Keep pressed the
seconds;
-
The dn (lower wall) symbol lights up on the display
-
Press the
button again;
-
The uP (upper wall) symbol lights up on the display.
2.8
Setting cool only or heat only modes
It is possible to deactivate the heating or the cooling
modes following a simple procedure.
Keep the A key on the touch-screen display pressed for
5 seconds until HC (heating and cooling) appears on the
display.
Press the A key for 1 second for the Co (cooling only)
button on the display for 5
in cooling mode, which increases the air flow in the room
(coanda effect).
This operation must be performed while the appliance
is switched off and disconnected.
A
High installation
Low installation (factory settings)
B
Block insert
1
-
If no other operations are performed in the following 2
seconds, the new setting is memorised.
For the appliance to work properly, each time the
configuration of the air outlet flap is modified, the
electronic control must be set.
mode.
Press the A key again for Ho (heating only) mode.
Wait for 3 seconds without touching anything to memorise
the setting.
INSTALLATION
EN
1
1
39
Publicidad
