Publicidad
Idiomas disponibles
Idiomas disponibles
Wall Bracket Installation for Drywall or
Studs
REQUIRED TOOLS (NOT INCLUDED)
1. Level
2. Pencil
MOUNTING THE WALL BRACKET
1. Loosen the bolt at the bottom of the main unit to take the wall
bracket off, using the T25 torx L-key.
2. Use a stud finder to locate the center of a wall stud. Use a
level and a pencil to draw a vertical line down the center of
the wall stud.
3. Hold the wall bracket against the installation surface. Align the
vertical line to the holes of the wall bracket. Firmly mount the
wall bracket using the provided screws.
WARNING: At least two screws must be fastened through the
bracket into the stud� For the other holes, it is recommended that
other secure drywall fastening means be utilized�
3. Stud finder
4. Philips screwdriver/bit
Hardwire Installation
DANGER: Ensure all power is off before starting to install the
hardwire� Installation of the hardwire should be carried out only by a
licensed and qualified electrician�
REQUIRED TOOLS (NOT INCLUDED)
1. Wire stripper
2. Crimping tool
PREPARING THE POWER SUPPLY WIRES
1. Strip each power supply wire to expose the conductors using
a wire stripper. The length of the stripped section should be
about 0.43" (11 mm).
2. Insert the stripped end of the wire into the crimp barrel of the
terminal, making sure that the strands are aligned and fully
inserted.
3. Use a crimping tool to crimp the terminal onto the wire.
CONNECTING THE POWER SUPPLY WIRES
NOTICE: The cable gland entry is recommended for 0�9 – 1�3"
(24 - 32 mm) cables�
1. Loosen the 4 screws on the cover plate on the back of the
main unit.
2. Feed the wires through the bottom port.
7
3. Philips screwdriver/bit
0.43" (11 mm)
TERMINAL
COVER PLATE
Publicidad
