Taurus HOMELAND POCKET Instrucciones De Uso página 9

• Turn the appliance on by using the on/off button.
ONCE YOU HAVE FINISHED USING THE APPLIANCE
• Turn the appliance off using the on/off button.
• Unplug the appliance from the mains.
• Retract the cable by pressing the roller cable button and
guide the cable into the appliance.
• Clean the appliance.
CARRY HANDLE
• This appliance has a handle to make it easy and
convenient to transport (Fig. 2).
PARKING POSITION
• This appliance has two parking positions for comfortable
and straightforward storage.
• To make use of the vertical parking, put the appliance in
a vertical position so that the back part of the appliance
is now leaning against the floor. Secure the hook of the
head in the hook which can be found on the lower part of
the appliance (Fig. 3).
• To make use of the horizontal parking hook, anchor the
hook of the shoe in the hook that is on the back of the
device (Fig. 4).
CLEANING
• Disconnect the appliance from the mains and allow it to
cool before undertaking any cleaning task.
• Clean the equipment with a damp cloth with a few drops
of washing-up liquid and then dry it.
• Do not use solvents or products with an acid or base pH,
such as bleach, or abrasive products, for cleaning the
appliance.
• Never submerge the appliance in water or any other liquid
or place it under running water.
CHANGING THE DUST BAG
• Change the dust bag when there is a noticeable reduction
in the suction power of the appliance. The dust bag
does not necessarily have to be full to need changing;
for example, if very fine dust has been vacuumed, this
can cover the pores in the bag and make it necessary to
replace it.
• In any case, change the bag when the full bag indicator
(H) is completely red.
• Disconnect the hose from the vacuum cleaners air intake.
• Open the bag compartment cover (Fig. 5).
• Remove the bag holder using the removal lever (Fig. 6).
• Remove the bag from the bag holder and clean it.
• Replace the bag with another one, fitting it to the bag
support (Fig. 7).
• Check the condition of the motor filter.
• Refit the bag holder into its housing.
• Close the bag compartment cover, making sure it is shut
properly.
• Connect the hose to the vacuum cleaner's air intake.
CHANGING THE FILTERS
• Motor filter: It is advisable to be changed at least once a
year or every 50 hours of the appliance's use.
• Air outlet HEPA filter (high-efficiency air filter that
efficiently retains spores, ash, sawdust, pollen, etc.): it is
advisable to change it a least once a year or after every
50 hours of use.
TO REMOVE THE FILTERS
• Inlet filter:
• Open the bag compartment lid (Fig. 5).
• Remove the bag unit for better access to the inlet filter.
• Remove the inlet filter by using the central tab and pulling
it upwards.
• Remove the filter from the grille, wash it and let it air dry.
• To fit the filter, proceed in reverse order to that described
in the previous section.
• Outlet filter:
• Remove the outer grille by pressing the outer tab and
pulling it outwards.
• Remove the HEPA filter by pressing the upper tab and
pulling it outwards.
• Wash the HEPA filter and let it air dry.
• To fit the filter, proceed in reverse order to the previous
section.
SUPPLIES
• Supplies for your appliance model, such as filters, can be
acquired from distributors and authorised establishments.