Specification - Multiplex Power peak C8 EQ-BID 12V/230V 180W Instrucciones De Uso

Power Peak ® C8 EQ-BID 180W
4.

SPECIFICATION

Operating voltage:
Cell counts:
Charge current:
Discharge current:
Equalizer current:
Trickle charge current:
Final discharge voltage:
Charge termination:
NC / NiMH:
Lead / Lithium
Dimensions:
Functions:
Protective functions:
Input:
Output:
Note:
If the input voltage falls below 11 V in DC mode, the output current is automatically reduced
by 1 A.
Reason: if the voltage of a car battery is less than 11 V (at the charger input, not at the
battery terminals), it can safely be assumed that the battery is too "weak" for the task in
hand, and reducing the charge current lessens the load on the battery. Without this function
the battery voltage would continue to fall, and the charger would eventually switch itself off
due to inadequate voltage. Reducing the charge current in this way allows you to continue
charging for as long as possible even when the battery is weak.
Maximum charge currents in AC or DC mode:
AC mode:
Up to 16.5 V battery voltage: 8.5 A
At higher battery voltages the current is reduced.
Note re. charging Lithium batteries without a sensor lead:
If you are using the BID system, it is possible to charge Lithium batteries even without a
voltage sensor lead. However, the battery is not balanced if you do this, and the charger is
unable to check the cell count.
Operating Instructions
12 V DC (car battery) / 230 V AC
(do not use a car battery charger!)
1 - 24 NC / NiMH cells
1 - 8 LiIo (3.6 V), LiPo (3.7 V), LiFe (3.3 V) cells
1 - 12 (2 ... 24 V) lead-acid cells
0.1 ... 10 A, max. 180 Watt, (12 V DC)
0.1 ... 10 A, max. 110 W (230 V AC)
0.1 ... 10 A (max. 35 Watt)
approx. 250 mA
C/20 maintenance charge
(NC and NiMH only)
0.8 V per cell, NC / NiMH
3.0 V per cell, LiPo, LiIo
2.5 V, LiFe
1.7 V per cell, Lead-Acid
automatic, digital Delta-Peak system
automatic, voltage-dependent, CC-CV method
180 x 145 x 70 mm
Charge, discharge, cycle, balance
Reverse polarity guard
Reverse polarity guard, short-circuit protection
DC mode:
Up to 20.5 V battery voltage: 8.5 A
31 7
# 30 8124