Descargar Imprimir esta página

SOLAC E903 Instrucciones De Uso página 13

Moldeador de aire con tecnología iónica

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
• E NG L ISH
• Read the instructions carefully before using the appliance. Keep the instruc-
tions for future consultation.
• Keep the appliance out of the reach of children, as well as the items of
packaging.
• Do not plug in the appliance without first checking that your home mains
voltage matches that stated on the nameplate.
• Never leave the appliance outdoors exposed to the elements.
• Do not touch the appliance with wet hands when it is working.
• DO NOT IMMERSE THE APPLIANCE IN WATER OR USE IT WHILE TAKING A
BATH OR SHOWER. MAKE SURE THAT NEITHER THE APPLIANCE NOR THE
POWER CORD GET SPLASHED.
• Do not use the appliance near the bath, washbasin or any other similar
receptacle containing water.
• The appliance should not be in contact with water while being cleaned.
• Never leave the appliance working on a wet surface or cloth.
• Unplug the appliance from the mains after use.
• When unplugging the appliance, do not pull on the power cord or the ap-
pliance..
• Do not let the attachments come in contact with your skin during use, as
they will get hot.
• Keep the appliance away from children as it contains small parts that could
be dangerous.
• Adult supervision is necessary when the appliance is to be used by a
child.
• If the appliance does not work, unplug it and do not tamper with it. If repair
is needed, please contact Customer Service.
• Never use the appliance if the power cord is damaged or the appliance has
a fault. Certain operations, such as replacing the power cord, will have to
be done at an authorized service centre as special tools are needed.
• This appliance is designed for domestic use only. Any other use apart from
what is specified in this handbook will be considered improper.
• The appliance is provided with an overload safety system, which means that
the appliance stops working if it overheats. This usually happens if the air
intake or outlet get blocked. If the moulder stops working during use, set
the switch at position 0 and wait for 5 minutes. Switch the appliance on
again after removing the cause of the blocking.
• For supplementary protection, we recommend installing a residual differen-
tial current device (RDD) not exceeding 30mA in the electrical circuit that
supplies the bathroom. Ask your installer for advice.
E-903 11
11
17/3/06, 10:19:53

Publicidad

loading