Mitsubishi Electric CITY MULTI PLFY-P VKM-E Serie Manual De Instrucciones página 5

3. Screen Configuration
Function Selection of remote controller
A
Standard Control Screens
OFF
B
Timer Monitor
MON
TIMER
OFF
°F°C
WEEKLY
4. Setting the Day of the Week and Time
TIME SUN
°C
TEMP.
2
MENU ON/OFF
BACK MONITOR/SET DAY
PAR-21MAA CLOCK
a
Note:
The day and time will not appear if clock use has been disabled at Function
Selection of remote controller.
5. Operation
2
3
°C
3
TEMP.
2
MENU ON/OFF
BACK MONITOR/SET DAY
PAR-21MAA CLOCK
5.1. Turning ON/OFF
<To Start Operation>
Press the ON/OFF button 1.
• The ON lamp 1 and the display area come on.
Note:
When the unit is restarted, initial settings are as follows.
Remote Controller settings
Mode Last operation mode
Temperature setting Last set temperature
Fan speed Last set fan speed
Airflow up/down Mode
* Last setting might be applied depending on the type of the indoor unit.
Set Day/Time
TIME SUN
D C
°F°C
°C
ON
C
Timer Setup
SUN MON TUE WED THU FRI SAT
B
1
Day of the Week
& Time display
°C
9
ON/OFF
4
FILTER
CHECK TEST
OPERATION CLEAR
6
4
5
8
°C
7
ON/OFF
1
FILTER
CHECK TEST
1
OPERATION
CLEAR
5
7 8 6
COOL or DRY Horiz. outlet *
HEAT Last setting
FAN Horiz. outlet *
<Screen Types>
For details on setting the language for the remote controller display, refer
to section 8. Function Selection.
The initial language setting is English.
Function Selection of remote controller:
Set Day/Time:
Standard Control Screens:
Timer Monitor:
Timer Setup:
<How to change the screen>
A : Hold down both the Operation mode button and the Timer On/Off
button for 2 seconds.
WEEKLY
B : Press the Timer Menu button.
C : Press the Operation mode (Back) button.
D : Press either of the Set Time buttons (
2
1. Press the or
2. Press the Timer On/Off (Set Day) button 9 to set the day.
* Each press advances the day shown at 3 : Sun → Mon → ... → Fri
→ Sat.
3. Press the appropriate Set Time button a as necessary to set the
time.
* As you hold the button down, the time (at 4) will increment first in
minute intervals, then in ten-minute intervals, and then in one-hour
intervals.
4. After making the appropriate settings at Steps 2 and 3, press the Filter
button 4 to lock in the values.
2
5
6
1
2
<To Stop Operation>
Press the ON/OFF button 1 again.
• The ON lamp 1 and the display area go dark.
Note:
Even if you press the ON/OFF button immediately after shutting down
the operation is progress, the air conditioner will not start for about three
minutes. This is to prevent the internal components from being damaged.
Set the functions and ranges available to the
remote controller (timer functions, operating
restrictions, etc.)
Set the current day of the week or time.
View and set the air conditioning system's
operating status
View the currently set timer (weekly timer,
simple timer, or Auto Off timer)
Set the operation of any of the timers (weekly
timer, simple timer, or Auto Off timer).
or ).
3 Day of the Week Setting
TIME SUN Time Setting
4
Set Time button a to show display 2.
3
7
3
5
6
7
5