JVC BR-DV3000E Manual De Instrucciones página 60

MENU SCREEN
REMOTE menu (continued)
Items
REM STOP SEL
PB START
DELAY
SYNCHRONI-
ZATION
NEXT PAGE
PAGE BACK
REMOTE (2/2) menu
Items
CONTROLLER
SEL
FOOT SW
PAGE BACK
E-60
Contents of the menus
–
Setting
EE Use this menu item to set the action to be performed when a
PB STANDBY ON command is received via the 9 PIN REMOTE ter-
minal or DV terminal:
EE: Sets the unit to the EE mode. (The unit will go into the STOP mode.)
PB: Sets the unit to the PLAY mode. (The unit will go into the STILL mode.)
0F Use this menu item to adjust the edit timing. When the remote con-
| troller is used, there will be a slight delay time before edit starts. To
15F rectify the time discrepancy, adjust the timing for starting playback:
0F
1F to 15F : Delay by the number of frames set by the user. When
OFF Use this setting to turn on/off the BUMP function when the unit is
ON connected to an editing remote controller:
OFF : No synchronization.
ON : Execute synchronization. The editing precision is enhanced .
Please set the pre-roll time to at least 7 seconds.
Display the REMOTE (2/2) menu.
Return to the top MENU.
Setting
TYPE1- When remote control is executed via the RS-422A interface, use
TYPE7 this menu item to set the type of controller connected:
TYPE1 : RM-G820
TYPE2 : RM-G860
TYPE3 : AG-A850
TYPE4 : RM-450,PVE-500
TYPE5 - TYPE7 : (not in use)
OFF Set this menu item when an external switch (e.g., a footswitch) is
L EDGE connected to the SERIAL REMOTE terminal. Before using an ex-
H EDGE ternal switch (footswitch), please engage the recording pause or
L LEVEL recording mode:
OFF
L EDGE
H EDGE
L LEVEL
Return to the REMOTE (1/2) menu.
Contents
: No compensation.
this unit is connected to an editing remote controller
with no BUMP (synchronization) function, use this set-
ting to adjust the editing precision.
Contents
: Use this setting if the external switch is not used.
: Recording and recording pause is switched at the
LOW edge of the external switch signal.
: Recording and recording pause is switched at the
HIGH edge of the external switch signal.
: Record at the LOW edge and pause recording at the
HIGH edge of the external switch signal.
– (continued)