Amica 10143.4TfPrDbJVXSp Manual De Instrucciones página 66

OPERATION
Menu / user programs
Select user programmes menu and touch
. 10 fully customisable user programmes
are available.
Operating user programmes
Using navigation sensor fields, select
a user program such as P0 and touch
confirm your selection. The appliance display
will show the default settings for all P0-P10
user programmes, which are the same as
those shown below: conventional cooking,
temperature 180°C and cook time 00:30.
If no changes are made within 3 minutes, the
appliance switches to standby mode.
Place food in the open, close the door and
touch . sensor field to start the programme.
The programme is started. In box 2 of the
preset programme COOK TIME changes
to END TIME and consequently cook time
of 0:30 is replaced with end time and the
remaining time is shown on the progress bar.
Once the programmed cook time has elap-
sed, all functions except cooling fan are tur-
ned off (see: Cooling fan operation) and an
acoustic signal is sounded (4 beeps / pause
/ 4 beeps).
The sequence is repeated every 3 seconds
for about 5 minutes. The display shows the
temperature set for the oven chamber and
END TIME and symbol is flashing.
Touch ,to acknowledge and mute the aco-
ustic signal. After this, the appliance switches
to standby mode.
Editing user programme settings
To modify the heating function and COOK
TIME, touch and hold
touch . sensor field. Function name and
, to
symbol start flashing in box 3.If no changes
are made within 3 minutes, the appliance
exits to upper menu (User Programmes) and
stores settings last shown on the display.
Only changes confirmed by touching
updated.
Touch . navigation sensor fields to chan-
ge the heating function. Available heating
functions are described in section Menu \
Heating functions.
Select the desired function and touch
sensor field to confirm. After touching the
sensor field, heating function symbol and
name stop flashing in box 3. At the same time
symbol start flashing and it is possible to
modify the temperature. If no changes are
made within 3 minutes, the appliance exits to
upper menu (User Programmes) and stores
settings last shown on the display. Only chan-
ges confirmed by touching
66
sensor field and then
are
.
are updated.