Makita SG1251 Manual De Instrucciones página 7

► 1. Shaft lock 2. Lock nut 3. Lock nut wrench
Rotate the diamond wheels while pressing the shaft
lock until it engages.
Remove the lock nut by rotating it counterclockwise with
the lock nut wrench.
Remove the diamond wheels and space rings.
Adjusting the groove width (the
distance between the two diamond
wheels)
Adjust the grooving width by changing the number of
the space rings as shown in the table.
Groove width: 30 mm
1
2
3
4
5
Groove width: 24 mm
Groove width: 18 mm
Groove width: 12 mm
Groove width: 6 mm
1. Lock nut 2. Diamond wheel 3. Space ring 6 (6 mm
thick) 4. Space ring 3 (3 mm thick) 5. Diamond wheel
1
2
3
Groove width: 27 mm
Groove width: 21 mm
Groove width: 15 mm
Groove width: 9 mm
Installing the diamond wheels
► 1. Shaft lock 2. Lock nut 3. Lock nut wrench
Mount the diamond wheel carefully onto the spindle.
Align the directions of the arrow on the diamond wheel
and the tool. Install space rings, the other diamond
wheel and the lock nut.
Tighten the lock nut securely clockwise with the lock nut
wrench while pressing the shaft lock.
2
► 1. Blade case 2. Diamond wheel
Return the blade case and tool base to the original
position and tighten the bolt to secure them.
Adjusting the front handle angle
2
► 1. Front handle 2. Bolt
Loosen the two bolts on both sides of the front handle
with the hex wrench. Move the front handle to your
desired angle and tighten the two bolts firmly.
7 ENGLISH
1
2
3
1
1