Makita SG1251 Manual De Instrucciones página 5

Symbols
The followings show the symbols used for tool.
volts
amperes
hertz
alternating current
rated speed
no load speed
Class II Construction
revolutions or reciprocation per minute
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Shaft lock
CAUTION:
• Never actuate the shaft lock when the spindle is
moving. The tool may be damaged.
1
► 1. Shaft lock
Press the shaft lock to prevent spindle rotation when
installing or removing accessories.
Sighting
► 1. Notch
There are notches on the front and rear of the base.
This is helpful for an operator to follow a straight cutting
line.
Adjusting the grooving depth
► 1. Scale 2. Clamping screw
The grooving depth can be adjusted between 0 mm and
30 mm (0" and 1-3/16").
Loosen the clamping screw and adjust the pointer to
your desired depth graduation on the scale.
Then tighten the clamping screw firmly.
Switch action
CAUTION:
• Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
5 ENGLISH
1
1
2