Brother 888-X74 Manual De Instrucciones página 14

KNOWING YOUR SEWING MACHINE — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
THREADING THE MACHINE
Winding the bobbin
CAUTION
We designed the bobbin that comes with this machine. If you use bobbins from other models,
G
the machine will not work properly. Only use the bobbin that comes with this machine or
bobbins of the same type (part code: SA156, SFB: XA5539-151). Using other bobbins may
cause damage to the machine. SA156 is Class 15 type bobbin.
(7/16 inch)
1
1 Pull the thread
in completely.
1 Pre-tension disk
Pull up the spool pin and put a spool of
1
thread on this pin.
While holding the thread from the spool
2
with your right hand, pass the thread
toward you, in the groove on the thread
guide. Then, pass the thread around the
pre-tension disk and pull the thread in
completely.
13
11.5 mm
This model
2 Bobbin winder shaft
Actual size
Other models
3 Bobbin
CAUTION
If the spool of thread is in the wrong
G
place, or is set incorrectly, the thread
may tangle on the spool pin.
2
3