FALMEC Fasteel Lux Isola 90 Inox Manual De Instrucciones página 23

Function of the
remote control
Light Key Pressing the Light key will switch the light on/off
' - ' Key
Pressing the '-' Key will decrease motor speed. If 1° (1st) speed is in gear, pressing the '-' key will turn off the motor
If the motor is turned off, pressing the '+' key will activate the motor at 1° (1st) speed. If the motor is operating, pressing the
' + ' Key
'+' key will increase motor speed up to the maximum.
Timer Key If the motor is active, pressing the timer key will activate/deactivate the timer function
Press the "Luce" (Light) key together with the "Timer" key of the remote control until the blue LED begins to slowly flash. If
the "-" key of the remote control is pressed within 5 seconds, the new code will be generated and memorised. Memorisation
Code Change is confirmed by 3 brief flashes of the LED.
(only in case of To return to the default code, apply pressure on the "-" key together with the "+" key for over 5 seconds. Memorisation of
malfunction) the default code will be signalled with 3 brief flashes of the LED.
Each time that a new code is generated or that the default code is set in the remote control, it is necessary to also carry out
the previously described Remote Binding (Light Key of the pushbutton) procedure.
H
FILTERS
REMOVING AND REPLACING'S INSTRUCTIONS
1. METAL FILTERS
To remove the metal grease-trapping filter, simply pull the handle A until releasing it from the front guide; then tilt it slightly down-
wards, and slide it out of the rear guide. To reposition the filter, repeat the operation in the reverse order.
Hoods with perimeter suction:
- Open the panel (see fig. 1). Use handle A to remove the metal grease filter.
A
2. CHARCOAL FILTERS
To replace the charcoal filters, proceed as follows: remove the metal filters as described above. The two filters located at the ends
of the motor can now be easily accessed.
To install the new fi lters see picture.
In case of hood with the motor box the fi lter is located on the botton part of the motor box.
To install the new fi lters see picture.
To order new charcoal fi lters contact the distributor/retailer.
VALID ONLY FOR ITALY: download the appropriate order form from: www.falmec.com (access the assistance drop-down menu).
3. REMOVABLE PANEL
Follow the instructions on fig. H3 to remove the panel.
I
LIGHTING
ASSEMBLY AND REPLACEMENT
1. SPOTLIGHT
How to replace a square halogen light:
a) Check that the equipment is disconnected from the power supply.
b) Open the panel completely till 90° (see figure) pressing the PUSH button
c) Replace the lamp with a similar one (halogen, max 20 W, 12 Volt, G4 connection).
d) Close the panel. If the panel does not close correctly repeat the operation at point b.
Square halogen light
DESCRIPTION
17