Descargar Imprimir esta página

THERMOBILE ITA 35 R Manual Del Usuario página 17

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 42
Caution
Use only diesel oil or paraffin.
Caution
Be careful when you fill the tank.
Remove any spilled oil from the
heater and the ground.
Gas oil tends to thicken at low
temperatures. This can block the
filters. Add a maximum of 15%
paraffin to the fuel at
temperatures below -5 °C, or
keep the fuel frost-proof, or use
tank heating (optional).
3. Make sure there is sufficient distance
between the wall and the air inlet.
Minimum distance is 1 m.
4. Make sure that the heated air can flow
without obstruction. Minimum distance
from outlet to an obstacle is 2 m.
5. Check the ventilation surface area: for
each kW a surface of 25 cm
6. Check the connection of the room
thermostat.
Do not remove the cap when you do not
use a room thermostat.
Remove the cap to connect a room
thermostat.
7. Install the flue (1 m and a raincover).
8. Make sure the I-0-II switch is in the 0
position.
9. Check the supply voltage: see the
identification plate.
10. Put the plug in the socket.
11. Press the reset switch.
Start heating.
3.3
Set the switch to position II to switch on the
heater.
Caution
Do not switch on the heater when the
tank is empty!
2. Set the room thermostat.
The heater supplies warm air after
approximately 10 seconds.
T I
/ A
T I
A
S
ITA 35 R
4.
4.1
is needed.
2
4.2
1. Switch off the heater.
2. Disconnect the electric power.
4
0
0 .
2
0
0 .
0
5
-
e r
. v
41.350.095 rev 01 - 2021
Caution
The fuel system de-aerates through the
nozzle. Close down may occur several
times when starting with an empty filter.
To rectify: press the reset switch.
3.3.1 Startup ventilation only
Set the switch to I to switch the
ventilation mode.
WARNING
Always use a filled diesel tank if the
machine operates in ventilation mode.
For pump damage due to dry running,
there is no warranty!
OPERATION
During operation
Hot
Do not touch the flue with rain cover,
nor the air outlet! The flue with rain
cover and the air outlet become hot
during operation!
Power down
The magnet valve closes and stops the
fuel supply.
Caution
After you switch off the heater, the
fan still rotates. The fan cools the
heater to avoid damage caused by
overheating. The fan stops
automatically.
Do not remove the plug from the
socket until the heater fully stops!
Caution
Do not disconnect the electric power
when using the tank heating.
0
7
-
2
0
1 1
English
1
7
17

Publicidad

loading