Publicidad
Idiomas disponibles
Idiomas disponibles
Setting Input Source
Short Press the Multi-Function button to switch
between Bluetooth (blue) and AUX IN (red) input
sources.
To enter Bluetooth Pairing Mode, Long Press the
Multi-Function button. The STATUS LED will begin to
flash blue. You may exit pairing mode at this stage by
short pressing the Multi-Function button.
To finish pairing, from your audio device select 'BT
CANS KICKER'. When successfully connected, the
STATUS LED will be solid blue. When the PowerCan
powers on in, or enters, Bluetooth mode, it will
automatically begin to search for and connect with
the last connected device.
Line Output & AUX IN
To use an external audio device as your input source,
connect it to the AUX IN jack using a 1/8" (3.5mm)
AUX cable, then set your input source to AUX IN. If
the Wired Remote is not installed, use your audio
device to control volume.
To send a line-level signal, connect a 1/8" (3.5mm)
AUX cable from the Line Output of the PowerCan to
your external audio device's line-level input.
AUX IN (black)
LINE-OUT (grey)
English
13
Publicidad
