Publicidad
Idiomas disponibles
Idiomas disponibles
3. If you're not using the KMLC, use the included
RGB Pigtail to hard-wire your LED. Connect the RGB
Pigtail to the male LED plug of the Right PowerCan.
When hard-wiring the LED lighting, the black lead is
+12V and the blue, red and green leads are ground.
Connect the black LED wire to the positive terminal of
the battery.
a. Place a 2-amp fuse (not included) no further than
7" away from the battery terminal.
b. Install a switch (not included) on the black LED
wire between the fuse and the speaker, so the LED's
can be turned off. Without a switch to turn them off,
they will always be on.
+12V
Connect the red, blue and/or green LED wires to the
negative terminal of the battery. See the Venn diagram
below for available combinations.
Green
English
Switch
Red
Yellow
White
Cyan
2A fuse
Ground
Magenta
Blue
≤7"
(17.5cm)
12V
battery
Red
Green
Blue
Red/Green
Red/Blue
Blue/Green
Red/Green/Blue
Red
Green
Blue
Yellow
Magenta
Cyan
White
8
Publicidad
