Descargar Imprimir esta página

Kicker PowerCans Serie Manual Del Propietário página 18

Publicidad

Idiomas disponibles

Idiomas disponibles

Troubleshooting
If the PowerCan becomes frozen or stuck, does not appear to be working,
or gives an error code, check the obvious things first such as blown fuses,
poor or incorrect wiring connections, etc.
No power? With a Volt Ohm Meter (VOM) check the following: Π+12 volt
power terminal (should read +12V to +16V)  Check for reversed power
and ground connections Ž Check Ground terminal for proper conductivity.
 Check fuses. Check that red & yellow ignition wire both have +12V.
Power on, no signal? Check the following: ΠAUX In/Out connections
and cables  Test audio source signal, either with a "known good" output
device or other means. Ž Audio source volume & PowerCan output volume
are increased.
Bluetooth device will not connect? On your mobile device: ΠTurn
Bluetooth off, then on again.  Remove 'BT CANS KICKER' from the
Bluetooth menu. Then pair again (see page 11). Ž Move your mobile
device closer to the speaker. Avoid obstacles that may block the wireless
signal.  Perform a software reset by pressing and holding the PLAY/
PAUSE button for 10 seconds (Bluetooth devices must be re-paired after
software reset).
No or low output? Œ Check the settings on the audio source.  Check
the speaker wiring, including AUX input and Line-level connections.
PowerCan frozen or stuck in operating procedure? ΠPerform a
software reset on the PowerCan  Cycle the power.
No Remote Function? Œ Check wiring.  Cycle the power.
CAUTION: When jump starting the vehicle, be sure that connections
made with jumper cables are correct. Improper connections can result in
blown fuses as well as the failure of other critical systems in the vehicle.
If you have more questions about the installation or operation of your new
KICKER product, see the Authorized KICKER Dealer where you made your
purchase. For more advice on installation, click on the SUPPORT tab on
the KICKER homepage, www.KICKER.com. Choose the TECHNICAL
SUPPORT tab, choose the subject you are interested in, and then
download or view the corresponding information. Please E-mail support@
KICKER.com or call Technical Services (405) 624-8583 for unanswered or
specific questions.
English
17

Publicidad

loading

Este manual también es adecuado para:

Powercans btcan65