SHERCO 500 SEF RACING 2024 Manual Del Propietário página 127

WHEELS, TIRES
CHECKING THE TIRE PRESSURE
Install the rear wheel in the swing arm and install the
axle (grease the axle prior to installation).
Mount the chain.
Install the chain tensioner
but do not tighten.
Check the chain tension ( p.122).
Tighten the nut
2
Rear axle nut
Operate the rear brake pedal several times until the
1
pads touch the disk.
Remove the bike from the stand.
Regularly check the tire pressure with a precision
pressure gauge.
- Remove the valve cap.
- Check air pressure when the tire is cold.
Tire air pressure when used in rough terrain.
Front
Rear
If the pressure does not comply with the above table:
- Correct the pressure.
- Replace the valve cap.
and install the nut
1
.
2
M24
0,9bar (13 psi)
0,9bar (13 psi)
2
100Nm
127