LOWES JENSON DN84MBK6LR Manual Del Usuario página 12

WIRING
1. Connect all GROUND (GREEN) wires from fan (on
downrod (A) and mounting bracket (B)) and remote control
receiver (O) to BARE/GREEN supply wire from ceiling.
Connect BLACK wire (labeled AC IN L) from remote
control receiver (O) to BLACK supply wire from ceiling.
Connect WHITE wire (labeled AC IN N) from remote
control receiver (O) to WHITE supply wire from ceiling.
Connect PINK wire (labeled TO MOTOR) from remote
control receiver (O) to PINK wire from motor housing (E).
Connect GRAY wire (labeled TO MOTOR) from remote
control receiver (O) to GRAY wire from motor housing (E).
Connect RED wire (labeled TO MOTOR) from remote
control receiver (O) to RED wire from motor housing (E).
Connect WHITE wire (labeled FOR LIGHT N) from remote
control receiver (O) to WHITE wire from motor housing (E).
Connect BLUE wire (labeled FOR LIGHT L) from remote
control receiver (O) to BLUE wire from motor housing (E).
2. Wrap electrical tape (not included) around each
individual wire connector (BB) down to the wire.
WARNING: Make sure no bare wire or wire
strands are visible after making connections. Place
GREEN and WHITE connections on opposite side
of the outlet box from the BLACK and BLUE (if
applicable) connections.
Hardware Used
BB
Wire Connector
Gently slide remote control receiver (O) flat-side up
3.
into mounting bracket (B). Turn spliced/taped wires
upward and gently push wires and wire connectors
into outlet box. Let antenna from remote control
receiver (O) hang to the side.
NOTE: The remote control included with this fan
meets the following requirements:
a. Not for use with solid state fans.
b. Electrical rating: 120V / 60 Hz;
motor amps:1.25 MAX.
motor: 65W MAX.
1
WHITE SUPPLY WIRE
BLACK SUPPLY WIRE
B
PINK
GRAY
FROM
FAN
GRAY
PINK
2
BB
x 6
3
12
GROUND (GREEN OR BARE)
RED
WHITE
BLUE
A
GREEN
/GROUND
BLUE
WHITE
O
ANTENNA
BB
B
Antenna
O
GROUND
(GREEN OR BARE)
WHITE
BLACK
FROM
CEILING
FROM
RECEIVER
BLACK
AC IN L
WHITE
AC IN N
BB