Publicidad
Idiomas disponibles
Idiomas disponibles
INITIAL INSTALLATION
7. Insert downrod (A) through canopy (C), canopy
cover (U) and yoke cover (D). NOTE: Canopy
cover (U) must be turned with the smooth side
toward the motor housing (E).
Then, thread wires from motor housing (E)
through downrod (A).
8. Slip downrod (A) into motor housing yoke, align
holes and re-install pin (J) and clip (K). Tighten
set screws in motor housing yoke and then tighten
preassembled nut on one of the set screws. Then,
slide yoke cover (D) down until it rests on top of
motor housing (E).
Depending on the length of downrod you use, you
9.
may need to cut the lead wires back to simplify
the wiring. If you decide to cut back the lead
wires, it is suggested you do so in the following
manner:
Take the lead wires and make sure you have
pulled them all the way through the top of the
downrod. Start at the TOP of the hanging ball on
the downrod and measure 8 in. of lead wire, then
cut the excess wire off with wire cutters (not
included).
NOTE: If you do not cut back the lead wires,
Steps 9 and 10 are not necessary and you may
proceed to Step 11 instead.
7
C
8
K
J
K
E
9
9
A
U
D
A
D
Set Screw &
8 in.
Hanging
Ball
Nut
J
Yoke
Publicidad
