YATO YT-82022 Manual Original página 10

PROPERTIES OF THE TOOL
The impact wrench is an ordinary electric tool, insulation Class II, which has been designed for unscrewing and tightening nuts
and bolts. Thanks to electric power supply it is not required to use a pneumatic system to work with the wrench. The tool has
been designed solely for household tasks and it must not be used professionally. A correct, reliable and safe functioning of the
tool depends on its proper use, so:
Before you proceed to operate the grinder, read the manual thoroughly and keep it.
The supplier will not be held responsible for any damage resulting from the safety regulations and the recommendations indicated
hereby not being observed.
EQUIPMENT
The wrench is supplied in a complete and does not require assembly. Along with the wrench supplied socket wrenches.
TECHNICAL PARAMETERS
Parameter
Catalogue number
Nominal voltage
Nominal frequency
Nominal power
Rotational speed
Maximum torque
Frequency of the impact action
Size of the drive
Electric protection class
Grade of protection (IPXX)
Mass
Level of noise
- L (pressure)
pA
- L (power)
wA
Vibration (impact tightening at maximum effi ciency)
GENERAL WARNINGS FOR THE SAFETY OF POWER TOOLS
Warning! Read all safety warnings, illustrations and specifi cations provided with this power tool. Failure to do so may
result in electric shock, fi re or serious injury.
Keep all warnings and instructions for future reference.
The term "power tool" used in warnings applies to all tools driven by power both wired and wireless.
Workplace safety
Keep the workplace well-lit and clean. Disorder and poor lighting can be causes of accidents.
Do not work with power tools in an environment with an increased risk of explosion, containing fl ammable liquids, gases
or vapors. Power tools generate sparks that can ignite dust or fumes.
Children and third persons should not be allowed to enter the workplace. Loss of concentration can result in loss of control.
Electrical safety
The plug of the electric cable must match the power socket. You must not modify the plug in any way. Do not use any
plug adapters with earthed power tools. An unmodifi ed plug that fi ts the outlet reduces the risk of electric shock.
Avoid contact with earthed surfaces such as pipes, radiators and coolers. Grounding the body increases the risk of electric shock.
Do not expose power tools to contact with atmospheric precipitation or moisture. Water and moisture that gets inside the
power tool increases the risk of electric shock.
Do not overload the power cable. Do not use the power cord to carry, pull or unplug the power plug from the power outlet.
Avoid contact of the power cable with heat, oils, sharp edges and moving parts. Damage or entanglement of the power cord
increases the risk of electric shock.
In the case of working outside closed rooms, use extension cords intended for work outside closed rooms. The use of an
extension cord adapted for outdoor use reduces the risk of electric shock.
O R I G I N A L
10
EN
Unit of measurement
[V]
[Hz]
[W]
[min ]
-1
[Nm]
[min ]
-1
['' / mm]
[kg]
[dB] (A)
[dB] (A)
[m/s ]
2
I N S T R U C T I O N S
Value
YT-82022
230
50
1020
2600
600
2700
1/2 / 12,5
II
IP20
3,7
100 ± 3
111 ± 3
18,9 ± 1,5