Franklin Electric INLINE 1100 Manual Para Propietarios página 2

SAFETY INSTRUCTIONS
Table of Contents
SAFETY INSTRUCTIONS
This equipment should be installed and serviced by technically qualified personnel who are familiar with the
correct selection and use of appropriate tools, equipment, and procedures. Failure to comply with national
and local electrical and plumbing codes and within Franklin Electric recommendations may result in electri-
cal shock or fire hazard, unsatisfactory performance, or equipment failure.
Read and follow instructions carefully to avoid injury and property damage. Do not disassemble or repair
unit unless described in this manual.
Refer to product data plate(s) for additional operating instructions and specifications.
Failure to follow installation or operation procedures and all applicable codes may result in the following
hazards:
Risk of severe injury or death.
• To reduce risk of electrical shock, disconnect power before working on or around the system. More
than one disconnect switch may be required to de-energize the equipment before servicing.
• Be certain that this pump is connected to a circuit equipped with a ground fault circuit interrupter
(GFCI) device if required by code.
• Check electrical outlets with a circuit analyzer to ensure power, neutral, and ground wires are prop-
erly connected. If not, a qualified, licensed electrician should correct the problem.
• Wire pump system for correct voltages.
• Make sure the ground terminal is connected to the motor, control enclosures, metal plumbing, and
other metal near the motor or cable using wire no smaller than motor cable wires.
• This pump has not been investigated for use in swimming pool or marine areas.
• Check local electrical and building codes before installation. The installation must be in accordance
with their regulations as well as the most recent National Electrical Code (NEC).
• Some pumps are supplied with lead wires and are intended to be hardwired using a junction box or
other approved enclosure. The pumps include a grounding connector. To reduce risk of electric
shock, be certain that it is properly connected to ground.
• Some pumps are supplied with a power cord including a grounding conductor and an integral
grounding-type attachment plug. To reduce risk of electric shock, be certain that it is connected only
to a properly grounded grounding-type receptacle. Do not remove the third prong from the plug.
The third prong is to ground the pump to help prevent possible electric shock hazard.
Risk of bodily injury, electric shock, or property damage.
• This equipment must not be used by children or persons with reduced physical, sensory or mental
abilities, or lacking in experience and expertise, unless supervised or instructed. Children may not
use the equipment, nor may they play with the unit or in the immediate vicinity.
• Equipment can start automatically. Lockout-Tagout before servicing equipment.
• Operation of this equipment requires detailed installation and operation instructions provided in this
manual for use with this product. Read entire manual before starting installation and operation. End
User should receive and retain manual for future use.
• Keep safety labels clean and in good condition.
• Keep work area clean, well-lit, and uncluttered.
• Pumping sand or other abrasives can damage the pump and void the warranty.
2