Franklin Electric INLINE 1100 Manual Para Propietarios página 6

INSTALLATION
Typical Installation
INSTALLATION
Typical Installation
1
2 4
3
1 Water Supply 5 Union Coupling
2 Check Valve 6 Inline System
3 Optional Bypass 7 Flow
4 Ball Valve 8 Power
Environmental Requirements
Risk of malfunction can occur due to improper handling, installation, or
environment.
• Handle with care to prevent damage to the plastic components.
• Do not mount on equipment with excessive vibration.
• Install in a location where temperature is within the range of product rating.
• Do not install in corrosive environments.
• Liquid-tight conduit and fittings must be used to maintain NEMA 4 rating.
• Installation in direct sunlight can reduce system power and reduce drive life.
Decide on a location for the pump installation that is:
• on a hard, level surface
• suitable to the enclosure rating of the system
• clean and well-ventilated
• protected from freezing, flooding, and excessive heat
• accessible for servicing
• convenient for draining of the pump housing, tank, and service pipes
• as close as possible to water source to minimize suction piping length
NOTE: When the pump is located at a distance from the water source, the piping may have to be
increased in diameter.
NOTE: The system is not designed to draw/lift water from a source below the pumping unit. There is
not an incoming flow requirement, other than that the system needs to be supplied with a constant
supply of water to keep the unit completely full of water at all times.
6
6
5 7
4
9 Pressure Shut-off
10 2 Gallon Tank
11 5 feet or less
12 Pressure Sensor
11
8
10
5
9
2
13 Pressure Gauge
14 Pressure Relief Valve
15 Discharge
16 To home
12
13
4
14
16
15