Electrolux EFC 80800 Montaje Y Modo De Empleo página 13

All manuals and user guides at all-guides.com
than 5 seconds. When you press this pushbutton the letter "A" will come up
on the display and then disappear after 5 seconds. The microprocessor
zeros the number of hours and starts a new count from zero until reaching
40 hours prompting this maintenance procedure.
- Prompt - replace active carbon filters (if mounted)
If your cooker hood utilizes the re-circulation air filtering system and
therefore is fitted out with active carbon filters for purifying the vapors
extracted, it is necessary that you program the microprocessor for this
extraction system. To do this, always with the cooker hood off (not powered),
maintain pushbutton nr. 4 pressed for 5 seconds. The symbol " –" will come
up on the display (this indicates the cooker hood is not provided with a
carbon filter) and after 5 seconds this symbol changes to "C" (now indicating
the cooker hood is provided with a carbon filter). After every 80 hours of use
the microprocessor will prompt the user to replace the carbon filter. This
prompt is indicated by the letter "C" which flashes on the display. This is to
guarantee better filtering performance and to improve hygiene.
To delete this prompt, once the filters have been replaced and with the
cooker hood off (not powered), maintain pushbutton 3 pressed for more
than 5 seconds. When you press this pushbutton the letter "C" will come up
on the display and then disappear after 5 seconds. The microprocessor
zeros the number of hours and starts a new count from zero until reaching
80 hours prompting this maintenance procedure.
Maintenance
ATTENTION! Before performing any maintenance operation, isolate the
hood from the electrical supply by switching off at the connector and
removing the connector fuse.
Or if the appliance has been connected through a plug and socket, then the
plug must be removed from the socket.
The cooker hood should be cleaned regularly (at least with the same
frequency with which you carry out maintenance of the fat filters) internally
and externally. Clean using the cloth dampened with neutral liquid
detergent. Do not use abrasive products. DO NOT USE ALCOHOL!
WARNING: Failure to carry out the basic cleaning recommendations of the
cooker hood and replacement of the filters may cause fire risks.
Therefore, we recommend observing these instructions.
The manufacturer declines all responsibility for any damage to the motor or
any fire damage linked to inappropriate maintenance or failure to observe
the above safety recommendations.
Grease filter
Fig. 8-24
The grease filter must be cleaned once a month using non aggressive
detergents, either by hand or in the dishwasher, which must be set to a low
temperature and a short cycle. When washed in a dishwasher, the grease
filter may discolour slightly, but this does not affect its filtering capacity.
Charcoal filter (filter version only)
Fig. 23
The saturation of the charcoal filter occurs after more or less prolonged use,
depending on the type of cooking and the regularity of cleaning of the grease
filter.
In any case it is necessary to replace the cartridge at least every four
mounths (or when the filter saturation indication system – if envisaged on the
model in possession – indicates this necessity).The charcoal filter may NOT
be washed or regenerated.
Replacing lamps
Fig. 26
Disconnect the hood from the electricity.
Warning! Prior to touching the light bulbs ensure they are cooled down.
Replace with a new 12 Volt, 20 Watt (Maximum) halogen light made for a G-
4 base SUITABLE FOR USE IN OPEN LUMINAIRES. Follow package
directions and do not touch new light with bare hands.
14