Preliminary Check; 5- Description Of Leds And Buttons On Board - Vimar ELVOX RS08 Manual De Instrucciones Para La Conexión Y El Uso

5 - Description of the LEDs and buttons on the card
Abbreviation Description
AC Shows whether there is mains power (lit if there is mains voltage)
STPA Displays the status of the STPA input (number 19), if not engaged the LED remains lit, if not used then jumper between terminal COM
and STPA
AP/CH Displays the status of the AP/CH input (number 14), if not engaged the LED remains off
APED Displays the status of the aped input (number 15), if not engaged the LED remains off
Displays the status of the stop input (number 17), if not engaged the LED remains lit, if not used then jumper between terminal COM
STOP
and STOP
Displays the status of the photo input (number 18), if not engaged the LED remains lit, if not used then jumper between terminal COM
FOTO
and FOTO.
Displays the motor 1 encoder input, on steady when the motor is moving at cyclical speed, flashing during slowdown, off with the
ENCM1
motor stopped.
Displays the motor 2 encoder input, on steady when the motor is moving at cyclical speed, flashing during slowdown, off with the
ENCM2
motor stopped.
DISPLAY Displays the programming menu status
Buttons in the circuit
Abbreviation Description
AP/CH
Controls opening and closing the gate
ESC Exit or go back to the lower level of the menu
Increases the displayed value by one unit or scrolling on the same menu level
UP
Decreases the displayed value by one unit or scrolling on the same menu level
DOWN
Confirms the value or moves to the top level of the menu, when pressed once while the gate is moving it shows the absorption of the
OK
electric motor M1 in Amps, when pressed 2 times while the gate is moving it shows the absorption of the electric motor M2 in Amps

Preliminary check:

After powering up the control panel, the display shows the name of the control panel RS08, the firmware version Fxxx, 3 flashes with the words FLSH and
ENC (if there is an encoder) and then switches off. Check the LEDs for diagnosis of the inputs, LEDs STOP, FOTO, STPA must be on.
Should one of the safety inputs (FOTO, STOP, STPA) not be used, insert a jumper between COM and the input not used.
EN
29 29