Jole fortifi R129 Manual De Instrucciones página 8

Idiomas disponibles

Installation Concerns

Recline Adjustment

see images

Press the recline adjustment handle, and adjust the child restraint to the

proper position.

There are four recline positions as shown in

Height Adjustment

for Head Support and Shoulder Harnesses

see images

Please adjust the head support and shoulder harnesses to proper height

according to the child's height.

When used with internal harness system (Harness Mode), the shoulder

harness slots must be even with or just above the child's shoulders.

When used in booster Mode, the shoulder belt guides must be even with

or just above the child's shoulders.

Squeeze the head support adjustment lever, meanwhile pull up or push down

the head support until it snaps into one of the 9 positions.

The head support positions are shown as

Side wings are able to open while the head support is adjusted to the 5

or any higher position.

Harness Mode

(

(Child height 76cm-105cm/Child weight 22kg/

15M - 4 years old)

see images

Please install the child restraint on the vehicle seat, and then put the child

in the child restraint.

i. Installation

Please adjust the shoulder harnesses to proper height before installing the

child restraint.

When installing and adjusting the safety belts, make sure that both the

shoulder belt and the waist belt are not twisted and will not keep the

safety belts from being properly positioned.

1. Thread the safety belt through the back slot at the back of the child

restraint.

2. Put the belt tongue into the female buckle end.