Installation And Assembly; Unpacking & Assembly - Surtek HG755 Manual De Usuario

INSTALLATION AND ASSEMBLY

Your pressure washer requires some assembly
and is ready for use after it has been properly
serviced with the recommended oil and fuel.
Tool need open-end wrench 10 mm, 14 mm, 17
mm.
UNPACKING
When unpacking check to make sure that all
parts are included. If any parts are missing or
broken, please call our distributor.
ASSEMBLY INSTRUCTIONS
1. Lift the frame with one hand and attach one
of the wheels by pressing the wheel's pin and
inserting the wheel shaft into the main frame .
Align the pin with the hole on the frame until
it snaps in. Repeat it for the opposite side.
18
2. Install the handle to the frame by sliding the
top handle posts into the frame posts and se-
cure them together using bolts, washers and
2 nuts (bolts, washers and nut in the manual
bag).
3. Install the gun holster to the frame by slid-
ing the top handle posts into the frame posts
and secure them together by using bolts, nut
and washer.
4. Attach the hose hook to the back of the
panel until it slides into place.
5. Assemble the spray gun with the metal
wand. Pull back the rubber piece to expose the
threaded fitting. Then, screw the two pieces
together and move the rubber piece back.
6. Connect the garden hose to the inlet of
pump.
7. Connect one end of the pressure hose to
pump outlet, and secure the plastic nut. Con-
nect the other end the pressure gun, and fas-
ten the hose.