Publicidad
Idiomas disponibles
Idiomas disponibles
9. Setting the tests
The DT70KV is a versatile instrument that allows you to carry out different
types of dielectric tests automatically and recorded in the internal
memory. It is necessary to properly define the tests to be performed,
configuring the following parameters before starting the measurements:
Maximum Current and the test class.
To select the test modes (glove class: 00, 0, 1, 2, 3 or 4) just press the
mode button
.
All configurations of the Dielectric Tester are made in the control module,
through the menu shown on the equipment's display.
Simply press the menu button
9.1. Maximum current
In this mode the operator will program the maximum current applied in the
test.
To configure these parameters, follow the instructions below:
• Access the device's MENU using the
• Use the control
• Use the control,
test or NO to perform the test without a current limit and press.
• When selecting YES, with the control,
and press
to confirm.
to access the Setup Test.
SETUP TEST
LANGUAGE
SETTINGS
, to select MAXIMUM CURRENT and press
to select YES to set the maximum current for the
23
DT
button.
to select the current value
70KV
.
.
Publicidad
