Toyotomi Zibro LC-140 Instrucciones De Uso página 21

E
CLEAN START
Clean start function reduces the odor emitted by the heater at the ignition
significantly. It takes one or two more minutes to ignite than normal mode.
By pressing the clean start key K while the heater is off, the indication
change to clean start mode.
Once the key is pressed again, the mode will turn off and return to the normal
ignition mode.
F
IGNITING THE HEATER
When used for the first time, a new heater may give out a smell for a short while.
You should therefore provide extra ventilation.
Al ays ignite the heater
cigarette lighter.
Just press the button ¹ to ignite the heater. The POWE lamp
indicating that the ignition procedure has started. This will take a short while.
Once the heater is burning, the POWE lamp
display ¸ will show two numbers. The light next to them indicates that these
numbers refer to the temperatures ( ig.
indicated belo OOM,
latter can be changed with the adjustment keys (refer to Section G).
Prior to igniting the heater, al ays check for sufficient fuel in the removable tank.
G
SETTING THE REQUIRED TEMPERATURE
The temperature setting can only be adjusted,
the adjustment keys
keys to switch on the function (the °C mark ¸ will start blinking). Next, adjust the
temperature using the key on the right ( min.) to set the temperature to a higher
setting and the key on the left ( hour) to lo er the temperature. Press once to
increase the value one step. After appro imately 10 seconds the C mark
blinking and the setting
The available temperature settings range from
When the heater has been unplugged (or after a power failure), the temperature
will reset to the factory setting of 20°C.
H
SWITCHING OFF THE HEATER
There are two ways to switch off the heater.
1 Press the button ¹. The information display will show the CLOCK
signal. Within approximately one minute the flame will have extinguished.
2 Press the TIME key
again with the timer the next time. This not only switches off the heater, but
it also activates the timer function.
All manuals and user guides at all-guides.com
ith the button ¹. Never use matches or a
ill remain lit (red). The information
). The actual room temperature is
hile the temperature setting is indicated belo
to adjust the temperature. irst press either of the t o
ill be locked ( ig. ).
, when you want to switch off the heater and ignite it
is lit and
ill start blinking,
SET. The
hen the heater is burning. Use
C minimum to 28 C ma imum.
G: The required tempe-
rature on the left, the
measured temperature
on the right.
ill stop
4
9