Sauder Cannery Bridge Serie Manual Del Usuario página 18

Step 14
Carefully turn your unit over onto its front edges. Unfold
å
the BACK (F) and lay it over your unit.
Make equal margins along the two long edges of the
å
BACK (F). Push on opposite corners of your unit if needed
to make it "square".
Fasten the BACK (F) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up
å
over the UPRIGHT (C).
NOTE: Perforations have been provided for access
å
through the BACK.
Tighten four HIDDEN CAMS in the BACK SKIRT (N).
å
NAIL
(53 used in this step)
The perforations
must be closer to
the bottom edge.
Page 18
1N
N
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
1
2
These holes must line up
over the UPRIGHT (C).
F
419151
The top edge of the
BACK and top surface
of the TOP should be
almost even.
www.sauder.com/services