Sauder Cannery Bridge Serie Manual Del Usuario página 7

Step 3
Carefully fl ip the ENDS (A and B) over.
å
Turn eight BLACK 9/16" FLAT HEAD SCREWS (32S) into
å
the ENDS (A and B) until the shoulders of the SCREWS
rest on the surfaces of the ENDS.
NOTE: Do not overtighten the SCREWS.
å
Slide the END MOLDINGS (Q) onto the ENDS (A and B).
å
Line up the grooves in the MOLDINGS over the heads of
the SCREWS in the ENDS.
NOTE: If the MOLDING comes up off of the SCREWS,
å
remove it and slide it on again.
These edges
should be even.
www.sauder.com/services
B
Q
BLACK 9/16" FLAT HEAD SCREW
(8 used in this step)
Q
A
Q
32S
419151
Remember:
Righty tighty.
Lefty loosey.
These edges
should be even.
Q
Q
Shoulder
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
Page 7