Sauder Cannery Bridge Serie Manual Del Usuario página 9

Step 5
Carefully fl ip the ENDS (A and B) over.
å
First, fi ll the holes in the FRONT LEGS (I and J) 1/4 to 1/2 full
å
with GLUE (54M). Then, insert two WOOD DOWELS (15F)
into the holes in each LEG. Wipe away the excess GLUE.
Now, fi ll the fi rst hole in the ENDS (A and B) 1/4 to 1/2
å
full with GLUE. Fasten the FRONT LEGS (I and J) to the
ENDS (A and B). Tighten eight HIDDEN CAMS. Wipe away
the excess GLUE.
Fill the holes in the short edges of the END MOLDINGS (O) 1/4
å
to 1/2 full with GLUE (54M). Fasten the END MOLDINGS (O) to
the FRONT LEGS (I and J). Tighten two HIDDEN CAMS. Wipe
away the excess GLUE.
These edges must be even.
These surfaces must be even.
1
2
www.sauder.com/services
These surfaces must be even.
B
J
15F
419151
Fill the holes 1/4 to 1/2 full with GLUE.
Caution
!
Inspect the parts thoroughly before
assembling. Disassembly of glued
parts is extremely diffi cult.
I
A
O
O
15F
54M
The LEG should
over hang the SKIRT.
Page 9