Cub Cadet CC 2000 Manuel Del Dueño/Operador página 13

Fig. 6-6
Fig. 6-7
Fig. 6-8
Fig. 6-9
12. Insert the ends of the line into the two holding slots
13. Insert the ends of the line through the eyelets in the
NOTE: The spring must be assembled on the inner
14. Hold the inner reel in place and install the bump knob
Installing a Pre Wound Reel
1. Hold the outer spool with one hand and unscrew the
Loop
2. Remove the old inner reel from the outer spool (Fig. 6-2).
3. Remove the spring from the old inner reel (Fig. 6-2).
4. Place the spring in the new inner reel.
NOTE: The spring must be assembled on the inner
5. Insert the ends of the line through the eyelets in the
6. Place the new inner reel inside the outer spool. Push
7. Hold the inner reel in place and install the bump knob
Holding Slots
Replacement Parts
For replacement parts, refer to the Accessories /
Replacement Parts section.
Maintenance (continued)
(Fig. 6-8).
outer spool and place the inner reel with spring inside
the outer spool (Fig. 6-9). Push the inner reel and
outer spool together. While holding the inner reel and
outer spool, grasp the ends and pull firmly to release
the line from the holding slots in the reel.
reel before reassembling the cutting
attachment.
by turning clockwise. Tighten securely.
bump knob counterclockwise (Fig. 6-1). Inspect the
bolt inside the bump knob to make sure it moves
freely. Replace the bump knob if damaged.
reel before reassembling the cutting
attachment.
outer spool (Fig. 6-9).
the inner reel and outer spool together. While holding
the inner reel and outer spool, grasp the ends and
pull firmly to release the line from the holding slots in
the reel.
by turning clockwise. Tighten securely.
13