Publicidad
Idiomas disponibles
Idiomas disponibles
Stop/
Off (O)
Fig. 5-1
Choke Lever
Primer Bulb
Fig. 5-2
Starter Rope
Throttle Control
(Squeezed)
Fig. 5-3
Operate this unit only in a well-ventilated outdoor
area. Carbon monoxide exhaust fumes can be
lethal in a confined area.
Avoid accidental starting. Make sure you are in the
starting position when pulling the starter rope
(Fig. 5-3). To avoid serious injury, the operator and
unit must be in a stable position while starting.
Start/
On (I)
On/Off Stop Control
Run
Start
Starting Instructions
1. Mix gas with oil. Fill fuel tank with fuel/oil mixture.
See Oil and Fuel Mixing Instructions.
2. Put the On/Off Stop Control in the ON (I) position
(Fig. 5-1).
3. Fully press and release the primer bulb 10 times,
slowly, until FUEL IS VISIBLE IN THE PRIMER
BULB (Fig. 5-2). If you can't see fuel in the bulb,
press and release the bulb as many times as it takes
before you can see fuel in it.
4. Place the choke lever in the START (
(Fig. 5-2).
5. With the unit in the starting position (Fig. 5-3), squeeze
the throttle control to the wide open (full throttle)
position. Pull the starter rope briskly 5 times while still
in the START (
) position. If the engine attempts to
run before the fifth pull, proceed to step 6.
6. Place the choke lever in the RUN ( ) position (Fig. 5-2).
7. Pull starter rope 1 to 3 times, briskly, to start the
engine (Fig. 5-3).
NOTE: Squeeze the throttle control until the engine
has started and warmed up.
8. If the engine does not start, repeat steps 3 through 7.
NOTE: If the engine floods while trying to start, place
the choke lever in the RUN (
(Fig. 5-2). Squeeze the throttle control. Pull the
starter rope briskly. The engine should start
within three (3) to eight (8) pulls.
9. Squeeze the throttle control to warm up the engine
for 5 to 10 seconds. Place the choke lever in the
RUN (
) position (Fig. 5-2).
NOTE: Choking is unnecessary when starting a
warm engine. Put the On/Off Stop Control in
the ON position (Fi. 5-1), and the choke lever
in the RUN (
) position (Fig. 5-2). Pull the
starter rope.
Stopping Instructions
1. Release your hand from the throttle control (Fig. 5-3).
Allow the engine to cool down by idling.
2. Put the On/Off Stop Control in the OFF (O) position
(Fig. 5-1).
Section 5
Operation
) position
) position
9
Publicidad
