IPC ML CMP D1310P M Manual De Instrucciones página 27

TIPS FOR DETERGENT USE
This high pressure washer has been designed for use with the
detergents supplied or recommended by the Manufacturer.
The use of other detergents or chemical products may jeopar-
dise the safety of the high pressure washer.
1) To ensure environmental compatibility, detergents should be
used rationally, following the instructions on the product pack.
2) From the range of recommended products, choose the
product most suitable for the washing to be performed and
dilute with water following the instructions on the pack or in the
catalogue of detergents suitable for the type of hot or cold high
pressure washer.
3) Ask your dealer for the detergents catalogue.
PROCEDURE FOR CORRECT WASHING USING DETER-
GENTS
1) Prepare the detergent so-
lution most suitable for the dirt
and surface to be washed.
2) Detach the extension from
the handgrip and fit the deter-
gent spray kit (fig. 7), operate
the high pressure washer
and spray the surface to be
washed, working from the
bottom upwards.
For the version with detergent
suction, activate the detergent
suction control on the lance
(fig. 8).
Leave to work for a few
minutes.
3) Rinse all the surface thoroughly with pressurised water,
proceeding from the top downwards.
4) After using the detergent, rinse the suction circuit. Place the
detergent suction hose (fig. 8) in a container of clean water and
operate the pump for 1 minute with the lance in the detergent
delivery phase.
USING THE ADJUSTABLE
HEAD (Vers. DS)
The adjustable head enables
you to select a low or high
pressure jet.
The pressure is selected by
rotating the head.
High pressure pos. A.
Low pressure pos. B.
English
FIG. 7
   
FIG. 8
PRESSURE REGULATION
This chapter applies to
models with "pressure re-
gulator" only. The pressure
regulator (fig. 9) enables
the working pressure to be
adjusted.
Turn the knob C anticlockwise
(B) (minimum) to reduce
working pressure.
ONLY THE OPERATIONS AUTHORISED IN THIS MANUAL
MAY BE PERFORMED BY THE USER.
ALL OTHER OPERATIONS ARE PROHIBITED.
! Danger
Maintenance of the high pressure pump, electrical parts and all
components with a safety function must be carried out by an
authorised technical service centre only.
The manufacturer is not liable in case of tampering, changes, in-
correct repairs or maintenance carried out on the machine by a
third person not provided with the manufacturer's authorization.
All documents pertaining to the repair and planned service
interventions, as well as any certificates concerning the de-
vice installation according to the laws in force (IEC 60364-1
standard) must be kept carefully by the user, together with the
Instructions Manual.
Periodically, at least once a year, have the safety devices and
the rated values checked at one of our technical service centres.
- 23 -
MAINTENANCE
FIG. 9