Publicidad
Idiomas disponibles
Idiomas disponibles
Installation and Operation: BXWP60002 and BXWP60005
WARNING RISK OF ELECTRICAL SHOCK: For corded
or battery operated drill follow drill manufacturers instructions.
Installation and Operation
NOTE:
It is recommended to add a few drops of lubricating
oil to the inlet port before each use to prevent impeller from
running dry.
1. Connect the pump drive shaft to the chuck of the drill
and tighten.
2. If desired, attach the drill pump to a solid surface by
securing with two screws (not included) through
mounting slots.
3. Attach the suction hose/s: (Hose/tubing is included only
with model BXWP60005)
A: Garden Hose: Attach the included garden hose
(model BXWP60005 only) or standard garden hose to
the inlet port of the pump. NOTE: Keep the inlet hose
as short as possible. The inlet hose should not exceed
more than 8 ft. vertical or 25 ft. horizontal distance.
B: Suction Tube: (included with model BXWP60005
only) Insert the 3 in. x 3/8 in. (76 x 9.5 mm) adapter
tube to the inside of the inlet port. Insert the 1/4 in. x
30 in. (6.4 x 762 mm ) suction tube to the inside of the
adapter tube. NOTE: The adapter and suction tubes are
a friction fit and should be fully inserted.
2
7*
4. Attach a standard garden hose to outlet port of the
pump. If the included garden hose is not being used on
the suction port, it may be used for the discharge.
5. Be certain that the suction hose/tube is fully submerged
into liquid source.
6. Connect the drill to the power source. (Refer to drill
manufacturer's instructions for proper operation.)
7. With drill in the forward position, press the trigger of the
drill to start pumping. NOTE: If pump fails to prime and
start pumping within 15-20 seconds, disconnect the drill
from the power source, fill intake hose with liquid and
restart the pumping process. Do not run the pump dry.
8. After each use, thoroughly flush the pump with clean
water.
Components
1 Drive Shaft
2 3/4 in. (19mm) GHT Suction Port
3 3/4 in. (19mm) GHT Discharge Port
4 36 in. x 3/4 in. (914 x 9mm) GHT Garden Hose**
5 30 in. x 1/4 in. (762 x mm) Suction Hose**
6 3 in. x 3/8 in. (76.2 mm) Adapter Tube**
7 Mounting Screws*
8 Drill*
8*
1
3
7*
9**
*Not Included
**Included in BXWP60005 Only
ENGLISH
3
Publicidad
